Certified End Suction Pumps

Features

  • Performance characteristics as per NFPA 20
  • Complete unit responsibility.
  • Complete in-house fabrication capabilities.
  • Hydrostatic strength testing facilities.
  • Operation run test as per NFPA 20, UL 448 and FM 1319 requirements.
  • End suction models for capacities from 50 to 500 US GPM.
  • Drivers: Electric motor drive or diesel engine drive.
  • Electrical testing capabilities for motors and controllers as per NFPA standards.
  • Capable to supply additional accessories wherever required.
  • Capable to supply single skid mounted fire pump set.

Pump Casing

The casing is designed for back pull-out which permits the removal of complete rotor unit without removing suction and discharge pipe. The cast iron volute casing is of robust design with integrally cast feet, vertical top centerline discharge with axial suction incorporating cast inlet vane to give best flow to impeller eye.

Bearings

Driven end / non-driven end bearing are grease lubricated deep groove ball bearings.

Impeller

Impeller is double shrouded type. It is hydraulically balanced and positively driven by shaft key and axially locked between sleeve and impeller nut.

Shaft Seal

Soft-packed stuffing box. Graphite impregnated type gland packing.

This site uses some unobtrusive cookies to store information on your computer. By using our site you accept our Terms And Conditions and Privacy Policy. ×